Modify wire list of a cable at any time. You may add or delete
wires or change the connector types using CableEye's netlist editor.
Start
1 +
| - Measure
a cable, or load a cable from the database, and click the "View
Netlist" button to see a wire list.
2 +
| - If you
would like to change connectors, click the connector name (left)
and make a new selection from the pop-up window that appears (right).
3 + | - To edit the wiring, click the "Pencil" button.
4 + | - Then, click on the cell you wish to edit and type in the new numbers. In this case, we have started to create a jumper between pins 1, 2, and 3 on the left and 1, 2, and 3 on the right.
5 + | - When finished editing, click the green "Checkmark" button to save your changes, or the red "X" button to discard them.
6 + | - Finally, view the wiring of your edited cable (below) by clicking the "View Wiring" button.
End of Topic -
Next Topic | Previous
Topic | Back to Beginning of This
Topic