You may design a completely new cable while at the same time
creating test data against which the first prototype can be measured.
You will use the same netlist editor for wire entry as was used
to add or delete wires from an existing cable. Start
1 +
| - Click
the "Alt" tab in the Test Data summary box, and then
click the "New" button to open a new design.
2 +
| - Choose
the connectors you need and click "OK" (not shown) at
the bottom of the window.
3 +
| - Enter
the wire list in the same way you edited connections previously.
Press the green checkmark button when all connections have been
entered.
4 +
| - Review
the cable's wiring to confirm the design (below). You may add
or remove wires at any time or, if necessary, change the gender
or type of the connectors. Annotate the final result with descriptive
notes, and save it in the database before finishing.
End of Topic -
Next Topic | Previous
Topic | Back to Beginning of This
Topic